First, the faucet installation

Both the faucet and the inlet pipe should be installed before installing the sink. When installing the faucet, not only the installation is required to be firm, but also the water penetration at the joint is not observed.

Second, place the sink

After installing some of the functional accessories of the sink, you can place the sink in the corresponding position in the countertop and prepare to start the next installation procedure.

Third, start to install the sink

1. Install the inlet pipe of the faucet

Connect one end of the inlet pipe installed on the faucet to the inlet switch. Pay attention to the firmness of the joint when installing. Also pay attention to a detail, that is, the position of the hot and cold water pipes. Do not confuse the left and right.

2. Install the drain pipe of the overflow hole

The overflow hole is a protection hole for avoiding the overflow of the water tank. Therefore, when installing the water pipe under the overflow hole, pay attention to the sealing property of the joint with the tank body, and ensure that the water pipe of the overflow hole does not leak water.

3. Install the drain pipe of the filter basket

When installing the down pipe under the filter basket, pay attention to the connection between the water pipe and the tank body, not only to be firm, but also to be sealed.

4, install the overall drain

Usually people buy a tank with two filter baskets, but the distance between the two sewer pipes is very close. When the workers are installed, the matching drain pipes will be cut according to the actual situation. At this time, pay attention to each interface. The seal between the two, the common water leakage problem occurs at these junctions.How to install the kitchen sink? The following Centry will tell you how to install the kitchen sink

5, install the hanging piece reinforcement tank

After the sink is placed in the countertop, it is necessary to install a matching hanging piece between the trough and the countertop, and the sink is firmly installed to avoid the small gap causing the trough to shake from side to side.

Fourth, installation acceptance

1. Carry out the drainage test

After the basic installation is completed, the filter basket is also installed, and the next experiment is started. When doing the drainage test, it is necessary to fill the water tank with water and test the drainage of the water from the two filter baskets and the overflow hole. When draining, if there is any water seepage, you should immediately rework to ensure that it will not be used in the future.

2, the edge around the tank

After the drainage test is completed, the sink can be sealed while ensuring that there are no problems. When sealing with silicone, ensure that the gap between the sink and the table is even and there is no water seepage.

Fifth, complete the sink installation

After the sealing is completed, the installation of the sink will be completed smoothly, and the sink is used frequently, so the connection of each launching station installed in the sink is the key.How to install the kitchen sink? The following Centry will tell you how to install the kitchen sink.