First, the kitchen double sink water pipe installation

1. Install the inlet pipe of the faucet

Connect one end of the inlet pipe installed on the faucet to the inlet switch. Pay attention to the firmness of the joint when installing. Also pay attention to the details, that is, the position of the hot and cold water pipes.

2. Install the drain pipe of the overflow hole

The overflow hole is a protection hole for avoiding the overflow of the water tank. Therefore, when installing the water pipe under the overflow hole, pay attention to the sealing property of the joint with the tank body, and ensure that the water pipe of the overflow hole does not leak water.

3. Install the drain pipe of the filter basket

When installing the down pipe under the filter basket, pay attention to the connection between the water pipe and the tank body, not only to be firm, but also to be sealed.

4, install the overall drain

Usually people buy a tank with two filter baskets, but the distance between the two sewer pipes is very close. When the workers are installed, the matching drain pipes will be cut according to the actual situation. At this time, pay attention to each interface. The seal between the two, the common water leakage problem occurs at these junctions.

5, install the hanging piece reinforcement tank

After the sink is placed in the countertop, it is necessary to install a matching hanging piece between the trough countertops, and the sink is firmly installed to avoid the small gaps causing the trough body to shake side to side.

Second, double sink water pipe installation precautions

1. Install the inlet pipe of the faucet. Connect one end of the inlet pipe installed on the faucet to the inlet switch. Pay attention to the firmness of the joint when installing. Also pay attention to a detail, that is, the position of the hot and cold water pipes. Make a mistake. 

2. The overflow pipe overflow hole for installing the overflow hole is a protection hole for avoiding the overflow of the water tank. Therefore, when installing the water pipe under the overflow hole, pay attention to the sealing property at the joint with the tank body, and ensure the water pipe of the overflow hole. It does not leak water.

3. Install the lower water pipe under the filter basket of the filter basket. When installing, pay attention to the connection between the lower water pipe and the tank body, not only to be firm, but also to be sealed. 

4, the installation of the overall drain pipe usually people will buy a tank with two filter baskets, but the distance between the two downpipes is close, when the workers are installed, the matching drain pipes will be cut according to the actual situation. At this point, pay attention to the tightness between each interface. Common water leakage problems occur at these joints.

Through the above examples, it can be known that the common kitchen double sink sewer pipes are all PC materials. There are many corresponding process steps and precautions during the installation process. First, you should refer to the appropriate order. For example, the first step is generally It is the inlet pipe for the faucet. The last step is to install the slat reinforcement groove. Secondly, it should also be combined with specific needs to formulate the material selection of the corresponding parts purchase plan and tools. Specifically, the above can be combined to understand and try to operate.